HELIX M ONE X - 24V Edition
Small, efficient and uncompromisingly stable – the M ONE X – 24V Edition is a highly compact monoblock for subwoofer applications. Designed from latest Class D technology this tiny amp can easily control speakers with 1 Ohm impedance. Its current capability makes the M ONE X – 24V Edition a perfect partner for 2 x 2 Ohms subwoofers, where both voice coils are connected in parallel. And for even more output power, two M ONE X – 24V Edition amplifiers can be combined to one single powerhouse – thanks to the TwinPower Link.
In addition a comprehensive and stunningly practical feature set leaves nothing to be desired. Last but not least installation will be a no-brainer due to the minimal dimensions.
Features
- Small footprint Class D amplifier with up to 1,180 Watts RMS output power @ 1 Ohm for easiest combination with all 2 x 2 Ohms subwoofers connected in parallel
- Start-Stop capability down to 12V supply voltage
- Smart highlevel input with ADEP circuit and Auto Turn-On function
- Integrated, active crossover with lowpass, bass boost, subsonic and phase control
- TwinPower Link for connecting two amplifiers in bridged mode
- Bass remote control for volume adjustment
- Low heat dissipation thanks to extraordinary efficiency
Special features
Smart highlevel input
The latest generation of OE car radios incorporates sophisticated possibilities of diagnosing the connected speakers. If a common amplifier will be hooked up failure messages and loss of specific features (e.g. fader function) quite often appear - but not with the M ONE X - 24V Edition.
The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without loading the speaker outputs of the OE radio during high volumes unnecessarily.
Start-Stop capability
The switched power supply of the HELIX M ONE X - 24V Edition assures operation even if the battery’s voltage drops down to 12 Volts during engine crank.
Technical data
| Power RMS ≤ 1% THD+N |
Normal operation
(One amplifier) |
TwinPower Link
(Two amplifiers) |
| - @ 4 Ohms |
1 x 400 Watts |
1 x 1,400 Watts |
| - @ 2 Ohms |
1 x 700 Watts |
1 x 2,060 Watts |
| - @ 1 Ohm |
1 x 1,030 Watts |
- |
| - bridged @ 4 Ohms |
- |
- |
| - bridged @ 2 Ohms |
- |
- |
| Max. output power per channel*: |
Up to 1,180 Watts RMS @ 1 Ohm |
| Amplifier technology |
Class D |
| Inputs |
2 x RCA / Cinch
2 x Highlevel speaker input
1 x Remote In
1 x Remote control input |
| Input sensitivity |
RCA / Cinch 0.5 - 6 Volts
Highlevel 1.1 - 13 Volts |
| Input impedance RCA / Cinch |
20 kOhms |
| Input impedance highlevel |
9 - 33 Ohms |
| Outputs |
1 x Speaker output |
| Output voltage RCA / Cinch |
- |
| Signal converter for digital input |
- |
| Frequency response |
10 Hz - 250 Hz |
| Bass boost |
0 - 12 dB / 30 - 80 Hz |
| Highpass |
- |
| Lowpass |
50 Hz - 250 Hz adjustable |
| Bandpass |
10 Hz - 250 Hz adjustable |
| Subsonic |
10 Hz - 50 Hz adjustable |
| Phase |
0 - 180° adjustable |
| Slope high- / lowpass |
- |
| Slope subsonic / lowpass |
12 / 24 dB/Oct. |
| Signal-to-noise ratio digital input |
- |
| Signal-to-noise ratio analog input |
95 dB (A-weighted) |
| Distortion (THD) |
0.20 % |
| Damping factor |
150 |
| Operating voltage |
18 - 36 Volts (max. 5 sec. down to 12 Volts) |
| Idle current |
400 mA |
| Operating temperature range |
-40° C to +70° C |
| Fuse |
3 x 20 A Maxi-fuse (APX) |
| Power rating |
DC 24 V ⎓ 53 A max. |
| Additional features |
Active, adjustable crossover, bass boost, phase shift, Start-Stop capability, highlevel input with automatic turn on function and Advanced Diagnostics Error Protection (ADEP), bass volume cable remote control |
| Dimensions (H x W x D) |
50 x 320 x 154 mm /
2.00 x 12.60 x 6.06” |
* In typical applications as subwoofer amplifier
Scope of delivery
1 x Amplifier HELIX M ONE X – 24V Edition
1 x Cable remote control
1 x Mounting material
1 x Instruction manual
